Home › Code lookup › P0336
Powertrain code · Engine

P0336 Crankshaft Position Sensor "A" Circuit Range/Performance

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine computer says the signal doesn't match what it expects from crankshaft position sensor A. This sensor tells the computer engine speed and piston position, so problems can cause stalling or a no-start.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: Be cautious: a failing crank sensor can make the engine stall without warning, even in traffic, and it may not restart until it cools. If it has stalled or stumbles, keep trips short and avoid highways until it's fixed. If it won't start, have it towed.

What to test before replacing parts

Check the crank signal on a scope, inspect the tone ring and sensor gap, and confirm cam and crank timing line up, since a stretched or jumped timing chain or belt can set this code.

  1. Check whether the tachometer moves while cranking
  2. Inspect the sensor's connector and wiring for oil, heat damage or chafing
  3. Test the sensor signal with a scope or meter before replacing it

Signs you may notice

  • Check engine light on
  • Engine stalls, often when warm, and may not restart until it cools
  • Cranks but won't start
  • Stumbling, misfiring or a jumpy tachometer

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed crankshaft position sensor
  • CommonDamaged wiring or loose, oil-soaked connector
  • PossibleTiming belt or chain stretched or jumped, so crank and cam signals don't line up
  • PossibleDamaged or loose reluctor (tone) ring on the crank or flywheel
  • PossibleExcess gap between sensor and tone ring, or metal debris on the sensor tip
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Most often a new crankshaft position sensor; check the wiring first, and use a quality brand part.

Repair costInsufficient verified pricing for this vehicle and repair
Replace crankshaft position sensor. Prepare an itemized shop request.
Walk through it step by step: Engine stalls while driving →

Common questions

What does P0336 mean?

The engine computer says the signal doesn't match what it expects from crankshaft position sensor A. This sensor tells the computer engine speed and piston position, so problems can cause stalling or a no-start.

Can I drive with code P0336?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: Be cautious: a failing crank sensor can make the engine stall without warning, even in traffic, and it may not restart until it cools. If it has stalled or stumbles, keep trips short and avoid highways until it's fixed. If it won't start, have it towed.

What causes P0336?

Common possibilities to test include: failed crankshaft position sensor; damaged wiring or loose, oil-soaked connector; timing belt or chain stretched or jumped, so crank and cam signals don't line up; damaged or loose reluctor (tone) ring on the crank or flywheel. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.