P0339 Crankshaft Position Sensor "A" Circuit Intermittent
What it means
The engine computer says the signal keeps dropping in and out from crankshaft position sensor A. This sensor tells the computer engine speed and piston position, so problems can cause stalling or a no-start.
Can I keep driving?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.
Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the sensor's connector and wiring for oil, heat damage or chafing
- Test the sensor signal with a scope or meter before replacing it
Signs you may notice
- Check engine light on
- Engine stalls, often when warm, and may not restart until it cools
- Cranks but won't start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed crankshaft position sensor
- CommonDamaged wiring or loose, oil-soaked connector
- PossibleDamaged or loose reluctor (tone) ring on the crank or flywheel
- PossibleExcess gap between sensor and tone ring, or metal debris on the sensor tip
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Most often a new crankshaft position sensor; check the wiring first, and use a quality brand part.
Common questions
What does P0339 mean?
The engine computer says the signal keeps dropping in and out from crankshaft position sensor A. This sensor tells the computer engine speed and piston position, so problems can cause stalling or a no-start.
Can I drive with code P0339?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0339?
Common possibilities to test include: failed crankshaft position sensor; damaged wiring or loose, oil-soaked connector; damaged or loose reluctor (tone) ring on the crank or flywheel; excess gap between sensor and tone ring, or metal debris on the sensor tip. A shop should confirm the cause before replacing parts.