Home › Code lookup › P0370
Powertrain code · Engine

P0370 Timing Reference High Resolution Signal A

How urgent? Get it checked in the next few days

What it means

The computer has a problem with a fine-detail timing signal, usually from the crankshaft sensor or an optical sensor in the distributor, that it uses to time spark and fuel precisely.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor wiring and connector, and check that ignition wires aren't touching it
  2. Test the sensor signal with a scope

Signs you may notice

  • Check engine light on
  • Stalling, misfire or rough running
  • Hard starting or no start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty crankshaft or distributor position sensor
  • CommonDamaged wiring or connector in the signal circuit
  • PossibleElectrical interference from ignition wires routed near the sensor wiring
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new crank or distributor sensor, or a wiring repair.

Walk through it step by step: Engine stalls while driving →

Common questions

What does P0370 mean?

The computer has a problem with a fine-detail timing signal, usually from the crankshaft sensor or an optical sensor in the distributor, that it uses to time spark and fuel precisely.

Can I drive with code P0370?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0370?

Common possibilities to test include: faulty crankshaft or distributor position sensor; damaged wiring or connector in the signal circuit; electrical interference from ignition wires routed near the sensor wiring; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.