P0371 Timing Reference High Resolution Signal A Too Many Pulses
What it means
The fine-detail timing signal A that the computer uses to time spark and fuel precisely is seeing more pulses than it should, often from electrical noise. It usually comes from a crankshaft or distributor sensor.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect sensor wiring and grounds, and keep ignition wires away from it
- Test the sensor signal with a scope
Signs you may notice
- Check engine light on
- Stalling, misfire or rough running
- Hesitation or surging
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty crankshaft or distributor position sensor
- CommonDamaged wiring or connector in the signal circuit
- PossibleElectrical interference from ignition wires, an aftermarket accessory or a bad ground
- PossibleDamaged tone ring or sensor disc
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually a new crank or distributor sensor, or a wiring or ground repair.
Common questions
What does P0371 mean?
The fine-detail timing signal A that the computer uses to time spark and fuel precisely is seeing more pulses than it should, often from electrical noise. It usually comes from a crankshaft or distributor sensor.
Can I drive with code P0371?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0371?
Common possibilities to test include: faulty crankshaft or distributor position sensor; damaged wiring or connector in the signal circuit; electrical interference from ignition wires, an aftermarket accessory or a bad ground; damaged tone ring or sensor disc. A shop should confirm the cause before replacing parts.