Home › Code lookup › P0385
Powertrain code · Engine

P0385 Crankshaft Position Sensor "B" Circuit

How urgent? Get it checked in the next few days

What it means

The engine computer says there's a fault in the circuit for crankshaft position sensor B, a second crank sensor used on some engines. Crank sensor problems can cause stalling or a no-start.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor's connector and wiring for oil, heat damage or chafing
  2. Test the sensor signal with a scope before replacing it

Signs you may notice

  • Check engine light on
  • Stalling or hard starting
  • Rough running or misfire

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed crankshaft position sensor B
  • CommonDamaged wiring or loose connector
  • PossibleDamaged tone ring or debris on the sensor tip
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new crankshaft position sensor or a wiring repair.

Walk through it step by step: Engine stalls while driving →

Common questions

What does P0385 mean?

The engine computer says there's a fault in the circuit for crankshaft position sensor B, a second crank sensor used on some engines. Crank sensor problems can cause stalling or a no-start.

Can I drive with code P0385?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0385?

Common possibilities to test include: failed crankshaft position sensor b; damaged wiring or loose connector; damaged tone ring or debris on the sensor tip; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.