Home › Code lookup › P0386
Powertrain code · Engine

P0386 Crankshaft Position Sensor "B" Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The engine computer says the signal doesn't match what it expects from crankshaft position sensor B, a second crank sensor used on some engines. Crank sensor problems can cause stalling or a no-start.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor's connector and wiring for oil, heat damage or chafing
  2. Test the sensor signal with a scope before replacing it

Signs you may notice

  • Check engine light on
  • Stalling or hard starting
  • Rough running or misfire

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed crankshaft position sensor B
  • CommonDamaged wiring or loose connector
  • PossibleTiming belt or chain stretched or jumped
  • PossibleDamaged tone ring or debris on the sensor tip
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new crankshaft position sensor or a wiring repair.

Walk through it step by step: Engine stalls while driving →

Common questions

What does P0386 mean?

The engine computer says the signal doesn't match what it expects from crankshaft position sensor B, a second crank sensor used on some engines. Crank sensor problems can cause stalling or a no-start.

Can I drive with code P0386?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0386?

Common possibilities to test include: failed crankshaft position sensor b; damaged wiring or loose connector; timing belt or chain stretched or jumped; damaged tone ring or debris on the sensor tip. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.