P0388 Crankshaft Position Sensor "B" Circuit High
What it means
The engine computer says the signal voltage is too high from crankshaft position sensor B, a second crank sensor used on some engines. Crank sensor problems can cause stalling or a no-start.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the sensor's connector and wiring for oil, heat damage or chafing
- Test the sensor signal with a scope before replacing it
Signs you may notice
- Check engine light on
- Stalling or hard starting
- Rough running or misfire
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed crankshaft position sensor B
- CommonDamaged wiring or loose connector
- PossibleDamaged tone ring or debris on the sensor tip
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually a new crankshaft position sensor or a wiring repair.
Common questions
What does P0388 mean?
The engine computer says the signal voltage is too high from crankshaft position sensor B, a second crank sensor used on some engines. Crank sensor problems can cause stalling or a no-start.
Can I drive with code P0388?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0388?
Common possibilities to test include: failed crankshaft position sensor b; damaged wiring or loose connector; damaged tone ring or debris on the sensor tip; engine computer fault. A shop should confirm the cause before replacing parts.