Home › Code lookup › P0405
Powertrain code · Emissions

P0405 Exhaust Gas Recirculation Sensor "A" Circuit Low

How urgent? Book a check when convenient

What it means

The sensor that tells the computer how much the EGR valve is open, or how much exhaust is flowing, is sending a signal that is lower than possible.

Can I keep driving?

Usually you can keep driving and book a repair; the car often drives normally. If you hear pinging under load, avoid hard acceleration and get it checked sooner.

What to test before replacing parts

Check the sensor's reference voltage, ground and signal at the connector for a short to ground, and test the sensor before replacing the EGR valve or sensor.

  1. Read the sensor voltage with key on and engine off
  2. Check the 5 volt reference and ground at the sensor
  3. Inspect wiring for chafing against the engine or exhaust

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • Possible pinging under load

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed EGR position or pressure (DPFE) sensor
  • CommonWiring shorted to ground
  • CommonCorroded or loose connector
  • PossibleFailed EGR valve with built-in sensor
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually replacing the EGR sensor, or the EGR valve if the sensor is built in.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EGR position or pressure sensor. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0405 mean?

The sensor that tells the computer how much the EGR valve is open, or how much exhaust is flowing, is sending a signal that is lower than possible.

Can I drive with code P0405?

Usually you can keep driving and book a repair; the car often drives normally. If you hear pinging under load, avoid hard acceleration and get it checked sooner.

What causes P0405?

Common possibilities to test include: failed egr position or pressure (dpfe) sensor; wiring shorted to ground; corroded or loose connector; failed egr valve with built-in sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.