Home › Code lookup › P0400
Powertrain code · Emissions

P0400 Exhaust Gas Recirculation Flow

How urgent? Get it checked in the next few days

What it means

The computer sees a problem with how much exhaust gas is being fed back into the engine by the EGR system. Too much or too little flow can both set this code.

Can I keep driving?

Usually you can keep driving and book a repair. If the engine stalls at stops or idles very rough, the valve may be stuck open; limit driving, since stalling in traffic is risky. If you hear pinging under load, avoid hard acceleration to protect the engine.

What to test before replacing parts

Command the EGR valve with a scan tool and watch engine response, check the passages for carbon, and test the EGR sensor and vacuum supply before replacing the valve.

  1. Look for other EGR codes that narrow down the problem
  2. Inspect vacuum hoses and wiring at the EGR valve
  3. Check whether the EGR valve opens and closes when commanded with a scan tool

Signs you may notice

  • Check engine light on
  • Rough idle or stalling if the EGR is stuck open
  • Pinging or knocking when accelerating if the EGR is not flowing
  • May fail an emissions test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonCarbon buildup clogging the EGR valve or passages
  • CommonFaulty EGR valve
  • CommonBad EGR pressure or position sensor
  • PossibleCracked or disconnected vacuum hose to the EGR valve
  • PossibleFaulty EGR control solenoid or wiring

Typical repair once the cause is confirmed

Usually cleaning carbon from the EGR valve and passages or replacing the EGR valve.

Repair costInsufficient verified pricing for this vehicle and repair

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P0400 mean?

The computer sees a problem with how much exhaust gas is being fed back into the engine by the EGR system. Too much or too little flow can both set this code.

Can I drive with code P0400?

Usually you can keep driving and book a repair. If the engine stalls at stops or idles very rough, the valve may be stuck open; limit driving, since stalling in traffic is risky. If you hear pinging under load, avoid hard acceleration to protect the engine.

What causes P0400?

Common possibilities to test include: carbon buildup clogging the egr valve or passages; faulty egr valve; bad egr pressure or position sensor; cracked or disconnected vacuum hose to the egr valve. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.