Home › Code lookup › P0406
Powertrain code · Emissions

P0406 Exhaust Gas Recirculation Sensor "A" Circuit High

How urgent? Book a check when convenient

What it means

The EGR position or pressure sensor is sending a signal that is higher than it should ever be, which usually points to a wiring or sensor problem.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check sensor voltage and ground at the connector
  2. Inspect the connector for water or corrosion

Signs you may notice

  • Check engine light on
  • Usually no change in driving
  • Possible rough idle

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed EGR position or pressure sensor
  • CommonOpen signal or ground wire
  • CommonSignal wire shorted to voltage
  • PossibleFailed EGR valve with built-in sensor

Typical repair once the cause is confirmed

Usually replacing the EGR sensor or the EGR valve assembly, or repairing wiring.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EGR position or pressure sensor. Prepare an itemized shop request.

Common questions

What does P0406 mean?

The EGR position or pressure sensor is sending a signal that is higher than it should ever be, which usually points to a wiring or sensor problem.

Can I drive with code P0406?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0406?

Common possibilities to test include: failed egr position or pressure sensor; open signal or ground wire; signal wire shorted to voltage; failed egr valve with built-in sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.