Home › Code lookup › P2218
Powertrain code · Emissions

P2218 NOx Sensor Heater Control Circuit/Open Bank 2

How urgent? Get it checked in the next few days

What it means

The engine computer can't properly control the NOx sensor heater (bank 2), which heats the NOx sensor so it can read accurately. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the NOx sensor connector and wiring
  2. Check for power at the connector and measure the part's resistance

Signs you may notice

  • Check engine light on
  • Possible emissions warning or reduced power on some diesels

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed NOx sensor (heater is built in)
  • CommonBroken wire or unplugged connector
  • PossibleBlown fuse or bad relay feeding the circuit
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the NOx sensor (heater is built in).

Repair costInsufficient verified pricing for this vehicle and repair

Common questions

What does P2218 mean?

The engine computer can't properly control the NOx sensor heater (bank 2), which heats the NOx sensor so it can read accurately. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I drive with code P2218?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2218?

Common possibilities to test include: failed nox sensor (heater is built in); broken wire or unplugged connector; blown fuse or bad relay feeding the circuit; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.