Home › Code lookup › P2223
Powertrain code · Emissions

P2223 NOx Sensor Heater Sense Circuit Low Bank 2

How urgent? Get it checked in the next few days

What it means

The signal from the NOx sensor heater (bank 2) is lower than the computer expects. This sensor heats the NOx sensor so it can read accurately. A wire shorted to ground or a failed sensor is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the NOx sensor wiring for rubbed-through or pinched spots
  2. Unplug the sensor and see if the reading changes, which helps separate wiring from sensor

Signs you may notice

  • Check engine light on
  • Possible emissions warning or reduced power on some diesels

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal or reference wire shorted to ground
  • CommonFailed NOx sensor (heater is built in)
  • PossibleCorroded or damaged connector
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the NOx sensor (heater is built in).

Repair costInsufficient verified pricing for this vehicle and repair

Common questions

What does P2223 mean?

The signal from the NOx sensor heater (bank 2) is lower than the computer expects. This sensor heats the NOx sensor so it can read accurately. A wire shorted to ground or a failed sensor is the usual reason.

Can I drive with code P2223?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2223?

Common possibilities to test include: signal or reference wire shorted to ground; failed nox sensor (heater is built in); corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.