Home › Code lookup › P2224
Powertrain code · Emissions

P2224 NOx Sensor Heater Sense Circuit High Bank 2

How urgent? Get it checked in the next few days

What it means

The signal from the NOx sensor heater (bank 2) is higher than the computer expects. This sensor heats the NOx sensor so it can read accurately. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the NOx sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • Possible emissions warning or reduced power on some diesels

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed NOx sensor (heater is built in)
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the NOx sensor (heater is built in).

Repair costInsufficient verified pricing for this vehicle and repair

Common questions

What does P2224 mean?

The signal from the NOx sensor heater (bank 2) is higher than the computer expects. This sensor heats the NOx sensor so it can read accurately. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P2224?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2224?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed nox sensor (heater is built in); wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.