Home › Code lookup › P2225
Powertrain code · Emissions

P2225 NOx Sensor Heater Sense Circuit Intermittent Bank 2

How urgent? Get it checked in the next few days

What it means

The signal from the NOx sensor heater (bank 2) keeps dropping out or jumping around. This sensor heats the NOx sensor so it can read accurately. A loose connection or a damaged wire is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the harness and connector while watching live data for dropouts
  2. Inspect the NOx sensor wiring along its whole route

Signs you may notice

  • Check engine light on
  • Possible emissions warning or reduced power on some diesels

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector
  • CommonChafed wire that opens or shorts as the engine moves
  • PossibleFailing NOx sensor (heater is built in)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the NOx sensor (heater is built in).

Repair costInsufficient verified pricing for this vehicle and repair

Common questions

What does P2225 mean?

The signal from the NOx sensor heater (bank 2) keeps dropping out or jumping around. This sensor heats the NOx sensor so it can read accurately. A loose connection or a damaged wire is the usual reason.

Can I drive with code P2225?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2225?

Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing nox sensor (heater is built in). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.