P2230 Barometric Pressure Circuit Intermittent
What it means
The signal from the barometric pressure sensor keeps dropping out or jumping around. This sensor measures outside air pressure so the computer can adjust for altitude. A loose connection or a damaged wire is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Wiggle the harness and connector while watching live data for dropouts
- Inspect the barometric sensor wiring along its whole route
Signs you may notice
- Check engine light on
- Possible hesitation or poor running
- Possible reduced power on turbo engines
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLoose or corroded connector
- CommonChafed wire that opens or shorts as the engine moves
- PossibleFailing barometric pressure sensor (on some cars built into the MAP sensor or computer)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the barometric pressure sensor (on some cars built into the MAP sensor or computer).
Common questions
What does P2230 mean?
The signal from the barometric pressure sensor keeps dropping out or jumping around. This sensor measures outside air pressure so the computer can adjust for altitude. A loose connection or a damaged wire is the usual reason.
Can I drive with code P2230?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2230?
Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing barometric pressure sensor (on some cars built into the map sensor or computer). A shop should confirm the cause before replacing parts.