Home › Code lookup › P2235
Powertrain code · Emissions

P2235 O2 Sensor Signal Circuit Shorted to Heater Circuit Bank 2 Sensor 2

How urgent? Book a check when convenient

What it means

Inside the oxygen sensor (bank 2, sensor 2) or its wiring, the signal wire is touching the heater wire. The computer can't trust the reading.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the O2 sensor wiring near the exhaust for melted spots
  2. Unplug the sensor and check for a short between signal and heater pins

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonInternally shorted oxygen sensor
  • CommonMelted or chafed sensor wiring touching the exhaust
  • PossibleWater or corrosion in the sensor connector

Typical repair once the cause is confirmed

Repair melted wiring if found; otherwise replace the oxygen sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace oxygen sensor. Prepare an itemized shop request.

Common questions

What does P2235 mean?

Inside the oxygen sensor (bank 2, sensor 2) or its wiring, the signal wire is touching the heater wire. The computer can't trust the reading.

Can I drive with code P2235?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2235?

Common possibilities to test include: internally shorted oxygen sensor; melted or chafed sensor wiring touching the exhaust; water or corrosion in the sensor connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.