P2237 O2 Sensor Positive Current Control Circuit/Open Bank 1 Sensor 1
What it means
The engine computer can't properly control the front air-fuel ratio sensor positive current control circuit (bank 1 sensor 1), which helps the computer run the wide-range front oxygen sensor. It sees an open or broken circuit, often from wiring, a connector or the part itself.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the front O2 sensor connector and wiring
- Check for power at the connector and measure the part's resistance
Signs you may notice
- Check engine light on
- Poor fuel economy
- Possible rough running or hesitation
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed front air-fuel ratio (wide-band O2) sensor
- CommonBroken wire or unplugged connector
- PossibleBlown fuse or bad relay feeding the circuit
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the front air-fuel ratio (wide-band O2) sensor.
Common questions
What does P2237 mean?
The engine computer can't properly control the front air-fuel ratio sensor positive current control circuit (bank 1 sensor 1), which helps the computer run the wide-range front oxygen sensor. It sees an open or broken circuit, often from wiring, a connector or the part itself.
Can I drive with code P2237?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2237?
Common possibilities to test include: failed front air-fuel ratio (wide-band o2) sensor; broken wire or unplugged connector; blown fuse or bad relay feeding the circuit; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.