P2249 O2 Sensor Reference Voltage Circuit Low Bank 2 Sensor 1
What it means
The signal from the front air-fuel ratio sensor reference voltage circuit (bank 2 sensor 1) is lower than the computer expects. This sensor helps the computer run the wide-range front oxygen sensor. A wire shorted to ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the front O2 sensor wiring for rubbed-through or pinched spots
- Unplug the sensor and see if the reading changes, which helps separate wiring from sensor
Signs you may notice
- Check engine light on
- Poor fuel economy
- Possible rough running or hesitation
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal or reference wire shorted to ground
- CommonFailed front air-fuel ratio (wide-band O2) sensor
- PossibleCorroded or damaged connector
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the front air-fuel ratio (wide-band O2) sensor.
Common questions
What does P2249 mean?
The signal from the front air-fuel ratio sensor reference voltage circuit (bank 2 sensor 1) is lower than the computer expects. This sensor helps the computer run the wide-range front oxygen sensor. A wire shorted to ground or a failed sensor is the usual reason.
Can I drive with code P2249?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2249?
Common possibilities to test include: signal or reference wire shorted to ground; failed front air-fuel ratio (wide-band o2) sensor; corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.