P2250 O2 Sensor Reference Voltage Circuit High Bank 2 Sensor 1
What it means
The signal from the front air-fuel ratio sensor reference voltage circuit (bank 2 sensor 1) is higher than the computer expects. This sensor helps the computer run the wide-range front oxygen sensor. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the front O2 sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- Poor fuel economy
- Possible rough running or hesitation
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed front air-fuel ratio (wide-band O2) sensor
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the front air-fuel ratio (wide-band O2) sensor.
Common questions
What does P2250 mean?
The signal from the front air-fuel ratio sensor reference voltage circuit (bank 2 sensor 1) is higher than the computer expects. This sensor helps the computer run the wide-range front oxygen sensor. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P2250?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2250?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed front air-fuel ratio (wide-band o2) sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.