P2255 O2 Sensor Negative Current Control Circuit Low Bank 2 Sensor 1
What it means
The control circuit for the front air-fuel ratio sensor negative current control circuit (bank 2 sensor 1) is reading low voltage. This part helps the computer run the wide-range front oxygen sensor. A wire shorted to ground or a shorted part is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the front O2 sensor wiring for rubbed-through insulation
- Measure the front O2 sensor resistance and compare with spec
Signs you may notice
- Check engine light on
- Poor fuel economy
- Possible rough running or hesitation
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire shorted to ground
- CommonInternally shorted front air-fuel ratio (wide-band O2) sensor
- PossibleDamaged connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the front air-fuel ratio (wide-band O2) sensor.
Common questions
What does P2255 mean?
The control circuit for the front air-fuel ratio sensor negative current control circuit (bank 2 sensor 1) is reading low voltage. This part helps the computer run the wide-range front oxygen sensor. A wire shorted to ground or a shorted part is the usual reason.
Can I drive with code P2255?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2255?
Common possibilities to test include: control wire shorted to ground; internally shorted front air-fuel ratio (wide-band o2) sensor; damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.