P2260 Secondary Air Injection System Control "B" Circuit High
What it means
The control circuit for the secondary air injection pump relay ("B") is reading high voltage. This part switches the pump that blows fresh air into the exhaust during cold starts to help the converter warm up. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the secondary air relay wiring for shorts to other wires
- Measure the secondary air relay resistance and compare with spec
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- May fail an emissions inspection
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed secondary air pump relay or pump
- CommonControl wire shorted to a power source
- PossibleOpen circuit or corroded connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the secondary air pump relay or pump.
Common questions
What does P2260 mean?
The control circuit for the secondary air injection pump relay ("B") is reading high voltage. This part switches the pump that blows fresh air into the exhaust during cold starts to help the converter warm up. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I drive with code P2260?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2260?
Common possibilities to test include: failed secondary air pump relay or pump; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.