Home › Code lookup › P2267
Powertrain code · Fuel and air

P2267 Water in Fuel Sensor Circuit High

How urgent? Book a check when convenient

What it means

The signal from the water-in-fuel sensor is higher than the computer expects. This sensor warns you when water collects in the diesel fuel filter. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the water-in-fuel sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • Water-in-fuel warning may stay on or not work

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed water-in-fuel sensor
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the water-in-fuel sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace water-in-fuel sensor. Prepare an itemized shop request.

Common questions

What does P2267 mean?

The signal from the water-in-fuel sensor is higher than the computer expects. This sensor warns you when water collects in the diesel fuel filter. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P2267?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2267?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed water-in-fuel sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.