Home › Code lookup › P2280
Powertrain code · Fuel and air

P2280 Air Flow Restriction / Air Leak Between Air Filter and MAF

How urgent? Book a check when convenient

What it means

Air is either being blocked or leaking in between the air filter and the airflow (MAF) sensor. The engine may run lean or rough.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the air filter, housing and ducts
  2. Smoke-test the intake for leaks

Signs you may notice

  • Check engine light on
  • Rough idle or hesitation
  • Possible hissing sound

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonClogged air filter
  • CommonLoose or cracked air filter housing or duct
  • PossibleDirty or faulty MAF sensor
  • PossibleCracked PCV hose

Typical repair once the cause is confirmed

Replace a clogged filter or repair the leak found.

Repair costInsufficient verified pricing for this vehicle and repair
Find and repair intake air leak. Prepare an itemized shop request.
Walk through it step by step: Rough idle or shaking when stopped →

Common questions

What does P2280 mean?

Air is either being blocked or leaking in between the air filter and the airflow (MAF) sensor. The engine may run lean or rough.

Can I drive with code P2280?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2280?

Common possibilities to test include: clogged air filter; loose or cracked air filter housing or duct; dirty or faulty maf sensor; cracked pcv hose. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.