Home › Code lookup › P2283
Powertrain code · Fuel and air

P2283 Injector Control Pressure Sensor Circuit

How urgent? Get it checked in the next few days

What it means

The engine computer has found a problem in the circuit for the injection control pressure (ICP) sensor, which reads the high oil pressure used to fire the fuel injectors on some diesels. It usually points to wiring, a connector or the sensor itself.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the ICP sensor connector and wiring for damage or corrosion
  2. Check the sensor power, ground and signal with a meter

Signs you may notice

  • Check engine light on
  • Hard starting or no start
  • Rough running or low power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty injection control pressure sensor
  • CommonDamaged, corroded or unplugged connector
  • PossibleBroken or chafed wiring
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the injection control pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace injection control pressure sensor. Prepare an itemized shop request.

Where it shows up

  • Used on oil-fired injection diesels such as the Ford Power Stroke 7.3L and 6.0L

Common questions

What does P2283 mean?

The engine computer has found a problem in the circuit for the injection control pressure (ICP) sensor, which reads the high oil pressure used to fire the fuel injectors on some diesels. It usually points to wiring, a connector or the sensor itself.

Can I drive with code P2283?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2283?

Common possibilities to test include: faulty injection control pressure sensor; damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.