Home › Code lookup › P2285
Powertrain code · Fuel and air

P2285 Injector Control Pressure Sensor Circuit Low

How urgent? Get it checked in the next few days

What it means

The signal from the injection control pressure (ICP) sensor is lower than the computer expects. This sensor reads the high oil pressure used to fire the fuel injectors on some diesels. A wire shorted to ground or a failed sensor is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the ICP sensor wiring for rubbed-through or pinched spots
  2. Unplug the sensor and see if the reading changes, which helps separate wiring from sensor

Signs you may notice

  • Check engine light on
  • Hard starting or no start
  • Rough running or low power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal or reference wire shorted to ground
  • CommonFailed injection control pressure sensor
  • PossibleCorroded or damaged connector
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the injection control pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace injection control pressure sensor. Prepare an itemized shop request.

Where it shows up

  • Used on oil-fired injection diesels such as the Ford Power Stroke 7.3L and 6.0L

Known on these vehicles

Common questions

What does P2285 mean?

The signal from the injection control pressure (ICP) sensor is lower than the computer expects. This sensor reads the high oil pressure used to fire the fuel injectors on some diesels. A wire shorted to ground or a failed sensor is the usual reason.

Can I drive with code P2285?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2285?

Common possibilities to test include: signal or reference wire shorted to ground; failed injection control pressure sensor; corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.