Home › Code lookup › P2287
Powertrain code · Fuel and air

P2287 Injector Control Pressure Sensor Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

The signal from the injection control pressure (ICP) sensor keeps dropping out or jumping around. This sensor reads the high oil pressure used to fire the fuel injectors on some diesels. A loose connection or a damaged wire is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the harness and connector while watching live data for dropouts
  2. Inspect the ICP sensor wiring along its whole route

Signs you may notice

  • Check engine light on
  • Hard starting or no start
  • Rough running or low power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector
  • CommonChafed wire that opens or shorts as the engine moves
  • PossibleFailing injection control pressure sensor

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the injection control pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace injection control pressure sensor. Prepare an itemized shop request.

Where it shows up

  • Used on oil-fired injection diesels such as the Ford Power Stroke 7.3L and 6.0L

Common questions

What does P2287 mean?

The signal from the injection control pressure (ICP) sensor keeps dropping out or jumping around. This sensor reads the high oil pressure used to fire the fuel injectors on some diesels. A loose connection or a damaged wire is the usual reason.

Can I drive with code P2287?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2287?

Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing injection control pressure sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.