Home › Code lookup › P2288
Powertrain code · Fuel and air

P2288 Injector Control Pressure Too High

How urgent? Get it checked in the next few days

What it means

The oil pressure used to fire the diesel fuel injectors is higher than it should be.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check engine oil level and condition
  2. Compare commanded and actual injection pressure in live data

Signs you may notice

  • Check engine light on
  • Rough running or knocking
  • Possible reduced power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty injection pressure regulator valve
  • CommonFaulty ICP sensor reading high
  • PossibleLow or wrong-grade engine oil
  • PossibleWiring or connector problem

Typical repair once the cause is confirmed

Repair the oil leak, regulator or sensor problem that testing points to.

Repair costInsufficient verified pricing for this vehicle and repair
Replace injection pressure regulator or ICP sensor. Prepare an itemized shop request.

Where it shows up

  • Seen on oil-fired injection diesels such as the Ford Power Stroke 7.3L and 6.0L

Common questions

What does P2288 mean?

The oil pressure used to fire the diesel fuel injectors is higher than it should be.

Can I drive with code P2288?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2288?

Common possibilities to test include: faulty injection pressure regulator valve; faulty icp sensor reading high; low or wrong-grade engine oil; wiring or connector problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.