Home › Code lookup › P2289
Powertrain code · Fuel and air

P2289 Injector Control Pressure Too High - Engine Off

How urgent? Get it checked in the next few days

What it means

The computer sees injection oil pressure while the engine is off, which shouldn't happen. Usually the pressure sensor is giving a false reading.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check engine oil level and condition
  2. Compare commanded and actual injection pressure in live data

Signs you may notice

  • Check engine light on
  • Often no running symptoms
  • Possible reduced power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty ICP sensor
  • CommonWiring or connector problem at the ICP sensor
  • PossibleLow or wrong-grade engine oil
  • PossibleWiring or connector problem

Typical repair once the cause is confirmed

Repair the oil leak, regulator or sensor problem that testing points to.

Repair costInsufficient verified pricing for this vehicle and repair
Replace injection pressure regulator or ICP sensor. Prepare an itemized shop request.

Where it shows up

  • Seen on oil-fired injection diesels such as the Ford Power Stroke 7.3L and 6.0L

Common questions

What does P2289 mean?

The computer sees injection oil pressure while the engine is off, which shouldn't happen. Usually the pressure sensor is giving a false reading.

Can I drive with code P2289?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2289?

Common possibilities to test include: faulty icp sensor; wiring or connector problem at the icp sensor; low or wrong-grade engine oil; wiring or connector problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.