Home › Code lookup › P2291
Powertrain code · Fuel and air

P2291 Injector Control Pressure Too Low - Engine Cranking

How urgent? Get it checked in the next few days

What it means

There isn't enough injection oil pressure while cranking for the injectors to fire, so the engine may not start.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check engine oil level and condition
  2. Compare commanded and actual injection pressure in live data

Signs you may notice

  • Check engine light on
  • Long crank or no start
  • Possible reduced power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLeaking high-pressure oil system (seals or fittings)
  • CommonWeak high-pressure oil pump or low engine oil
  • PossibleLow or wrong-grade engine oil
  • PossibleWiring or connector problem

Typical repair once the cause is confirmed

Repair the oil leak, regulator or sensor problem that testing points to.

Repair costInsufficient verified pricing for this vehicle and repair
Replace injection pressure regulator or ICP sensor. Prepare an itemized shop request.

Where it shows up

  • Seen on oil-fired injection diesels such as the Ford Power Stroke 7.3L and 6.0L

Known on these vehicles

Walk through it step by step: Car won't start →

Common questions

What does P2291 mean?

There isn't enough injection oil pressure while cranking for the injectors to fire, so the engine may not start.

Can I drive with code P2291?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2291?

Common possibilities to test include: leaking high-pressure oil system (seals or fittings); weak high-pressure oil pump or low engine oil; low or wrong-grade engine oil; wiring or connector problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.