Home › Code lookup › P2294
Powertrain code · Fuel and air

P2294 Fuel Pressure Regulator 2 Control Circuit

How urgent? Get it checked in the next few days

What it means

The engine computer can't properly control the fuel pressure regulator 2, which controls fuel pressure in a second fuel circuit, such as the high-pressure side on direct-injection engines. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the fuel pressure regulator connector and wiring
  2. Check for power at the connector and measure the part's resistance

Signs you may notice

  • Check engine light on
  • Hard starting
  • Hesitation, stalling or low power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed fuel pressure regulator 2
  • CommonBroken wire or unplugged connector
  • PossibleBlown fuse or bad relay feeding the circuit
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the fuel pressure regulator 2.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel pressure regulator. Prepare an itemized shop request.

Common questions

What does P2294 mean?

The engine computer can't properly control the fuel pressure regulator 2, which controls fuel pressure in a second fuel circuit, such as the high-pressure side on direct-injection engines. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I drive with code P2294?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2294?

Common possibilities to test include: failed fuel pressure regulator 2; broken wire or unplugged connector; blown fuse or bad relay feeding the circuit; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.