P2295 Fuel Pressure Regulator 2 Control Circuit Low
What it means
The control circuit for the fuel pressure regulator 2 is reading low voltage. This part controls fuel pressure in a second fuel circuit, such as the high-pressure side on direct-injection engines. A wire shorted to ground or a shorted part is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the fuel pressure regulator wiring for rubbed-through insulation
- Measure the fuel pressure regulator resistance and compare with spec
Signs you may notice
- Check engine light on
- Hard starting
- Hesitation, stalling or low power
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire shorted to ground
- CommonInternally shorted fuel pressure regulator 2
- PossibleDamaged connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the fuel pressure regulator 2.
Common questions
What does P2295 mean?
The control circuit for the fuel pressure regulator 2 is reading low voltage. This part controls fuel pressure in a second fuel circuit, such as the high-pressure side on direct-injection engines. A wire shorted to ground or a shorted part is the usual reason.
Can I drive with code P2295?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2295?
Common possibilities to test include: control wire shorted to ground; internally shorted fuel pressure regulator 2; damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.