Home › Code lookup › P2296
Powertrain code · Fuel and air

P2296 Fuel Pressure Regulator 2 Control Circuit High

How urgent? Get it checked in the next few days

What it means

The control circuit for the fuel pressure regulator 2 is reading high voltage. This part controls fuel pressure in a second fuel circuit, such as the high-pressure side on direct-injection engines. A wire shorted to power, an open circuit or a failed part is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the fuel pressure regulator wiring for shorts to other wires
  2. Measure the fuel pressure regulator resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Hard starting
  • Hesitation, stalling or low power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed fuel pressure regulator 2
  • CommonControl wire shorted to a power source
  • PossibleOpen circuit or corroded connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the fuel pressure regulator 2.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel pressure regulator. Prepare an itemized shop request.

Common questions

What does P2296 mean?

The control circuit for the fuel pressure regulator 2 is reading high voltage. This part controls fuel pressure in a second fuel circuit, such as the high-pressure side on direct-injection engines. A wire shorted to power, an open circuit or a failed part is the usual reason.

Can I drive with code P2296?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2296?

Common possibilities to test include: failed fuel pressure regulator 2; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.