Home › Code lookup › P2299
Powertrain code · Speed and idle control

P2299 Brake Pedal Position / Accelerator Pedal Position Incompatible

How urgent? Get it checked in the next few days

What it means

The computer saw the brake and gas pedals pressed at the same time, or a sensor said they were. As a safety step it may cut engine power.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure floor mats aren't touching the pedals
  2. Check that the brake lights work and turn off when released

Signs you may notice

  • Check engine light on
  • Reduced engine power while braking
  • Brake lights may stay on or not work

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDriver resting a foot on both pedals
  • CommonFaulty or misadjusted brake light switch
  • PossibleFloor mat pressing the gas pedal
  • PossibleFaulty accelerator pedal sensor

Typical repair once the cause is confirmed

Adjust or replace the brake light switch if faulty and correct any pedal interference.

Repair costInsufficient verified pricing for this vehicle and repair
Replace brake light switch. Prepare an itemized shop request.
Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2299 mean?

The computer saw the brake and gas pedals pressed at the same time, or a sensor said they were. As a safety step it may cut engine power.

Can I drive with code P2299?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2299?

Common possibilities to test include: driver resting a foot on both pedals; faulty or misadjusted brake light switch; floor mat pressing the gas pedal; faulty accelerator pedal sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.