P2513 Event Data Recorder Request Circuit Low
What it means
The computer is watching the event data recorder request circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is the line used to tell the crash data recorder to save information. It does not affect how the car drives.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the event data recorder request circuit for rubbed-through insulation touching metal
- Check the wiring for a short to ground with a meter
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWiring or connector fault between the modules
- CommonLoose or corroded connector
- PossibleAirbag or crash data module fault
- PossibleEngine computer fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector between the modules; module replacement is rarely needed.
Common questions
What does P2513 mean?
The computer is watching the event data recorder request circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is the line used to tell the crash data recorder to save information. It does not affect how the car drives.
Can I drive with code P2513?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2513?
Common possibilities to test include: wiring or connector fault between the modules; loose or corroded connector; airbag or crash data module fault; engine computer fault (rare). A shop should confirm the cause before replacing parts.