Home › Code lookup › P2525
Powertrain code · Engine

P2525 Vacuum Reservoir Pressure Sensor Circuit

How urgent? Get it checked in the next few days

What it means

The computer is watching the vacuum reservoir pressure sensor and has spotted an electrical fault. It reports how much vacuum is stored for systems such as the brake booster or emissions actuators.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the vacuum reservoir pressure sensor, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Brake pedal may feel harder than normal
  • Some vacuum-operated controls may not work

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the vacuum reservoir pressure sensor
  • CommonBroken or chafed wire in the vacuum reservoir pressure sensor circuit
  • CommonFailed vacuum reservoir pressure sensor
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the vacuum reservoir pressure sensor.

Walk through it step by step: Hard brake pedal →

Common questions

What does P2525 mean?

The computer is watching the vacuum reservoir pressure sensor and has spotted an electrical fault. It reports how much vacuum is stored for systems such as the brake booster or emissions actuators.

Can I drive with code P2525?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2525?

Common possibilities to test include: unplugged, loose or corroded connector at the vacuum reservoir pressure sensor; broken or chafed wire in the vacuum reservoir pressure sensor circuit; failed vacuum reservoir pressure sensor; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.