P2539 Low Pressure Fuel System Sensor Circuit
What it means
The computer is watching the low-pressure fuel sensor and has spotted an electrical fault. This sensor reads fuel pressure coming from the tank pump, before the high-pressure pump on direct-injection engines.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the low-pressure fuel sensor, checking for damage, corrosion or a loose fit
- Check power, ground and signal with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine light on
- Hesitation or loss of power
- Hard starting or stalling in some cases
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the low-pressure fuel sensor
- CommonBroken or chafed wire in the low-pressure fuel sensor circuit
- CommonFailed low-pressure fuel sensor
- PossibleMissing reference voltage or ground from the computer
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the low-pressure fuel sensor.
Common questions
What does P2539 mean?
The computer is watching the low-pressure fuel sensor and has spotted an electrical fault. This sensor reads fuel pressure coming from the tank pump, before the high-pressure pump on direct-injection engines.
Can I drive with code P2539?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2539?
Common possibilities to test include: unplugged, loose or corroded connector at the low-pressure fuel sensor; broken or chafed wire in the low-pressure fuel sensor circuit; failed low-pressure fuel sensor; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.