Home › Code lookup › P2542
Powertrain code · Fuel and air

P2542 Low Pressure Fuel System Sensor Circuit High

How urgent? Get it checked in the next few days

What it means

The computer is watching the low-pressure fuel sensor and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor reads fuel pressure coming from the tank pump, before the high-pressure pump on direct-injection engines.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the low-pressure fuel sensor
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Hesitation or loss of power
  • Hard starting or stalling in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire shorted to voltage or a broken ground wire
  • CommonFailed low-pressure fuel sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the low-pressure fuel sensor.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2542 mean?

The computer is watching the low-pressure fuel sensor and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor reads fuel pressure coming from the tank pump, before the high-pressure pump on direct-injection engines.

Can I drive with code P2542?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2542?

Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed low-pressure fuel sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.