P2547 Torque Management Request Input Signal "A" High
What it means
The computer is watching the torque management request signal and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Another module (often the transmission computer) uses this signal to ask the engine to cut power briefly, such as during shifts.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the torque management request signal
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Harsh or firm shifts
- Reduced power mode possible
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWiring or connector fault between the engine and transmission computers
- CommonNetwork communication problem between modules
- PossibleModule software that needs an update
- PossibleTransmission or engine computer fault
Typical repair once the cause is confirmed
Repair the wiring or network fault, or update the module software as the maker directs.
Common questions
What does P2547 mean?
The computer is watching the torque management request signal and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Another module (often the transmission computer) uses this signal to ask the engine to cut power briefly, such as during shifts.
Can I drive with code P2547?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2547?
Common possibilities to test include: wiring or connector fault between the engine and transmission computers; network communication problem between modules; module software that needs an update; transmission or engine computer fault. A shop should confirm the cause before replacing parts.