Home › Code lookup › P2550
Powertrain code · Computer

P2550 Torque Management Request Input Signal "B" Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the torque management request signal and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Another module (often the transmission computer) uses this signal to ask the engine to cut power briefly, such as during shifts.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the torque management request signal for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Harsh or firm shifts
  • Reduced power mode possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWiring or connector fault between the engine and transmission computers
  • CommonNetwork communication problem between modules
  • PossibleModule software that needs an update
  • PossibleTransmission or engine computer fault

Typical repair once the cause is confirmed

Repair the wiring or network fault, or update the module software as the maker directs.

Walk through it step by step: Harsh or late shifting →

Common questions

What does P2550 mean?

The computer is watching the torque management request signal and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Another module (often the transmission computer) uses this signal to ask the engine to cut power briefly, such as during shifts.

Can I drive with code P2550?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2550?

Common possibilities to test include: wiring or connector fault between the engine and transmission computers; network communication problem between modules; module software that needs an update; transmission or engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.