Home › Code lookup › P2552
Powertrain code · Computer

P2552 Throttle/Fuel Inhibit Circuit

How urgent? Get it checked in the next few days

What it means

The computer is watching the throttle/fuel inhibit circuit and has spotted an electrical fault. This circuit lets another module tell the engine to limit throttle or fuel, for example for safety or security.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the throttle/fuel inhibit circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Reduced power or engine may not rev
  • Engine may not start in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWiring or connector fault in the inhibit circuit
  • CommonFault in the module that sends the inhibit request
  • PossibleAftermarket remote start or alarm wired into the circuit
  • PossibleEngine computer fault (rare)

Typical repair once the cause is confirmed

Repair the inhibit circuit wiring or the module sending the signal; remove faulty aftermarket add-ons.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2552 mean?

The computer is watching the throttle/fuel inhibit circuit and has spotted an electrical fault. This circuit lets another module tell the engine to limit throttle or fuel, for example for safety or security.

Can I drive with code P2552?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2552?

Common possibilities to test include: wiring or connector fault in the inhibit circuit; fault in the module that sends the inhibit request; aftermarket remote start or alarm wired into the circuit; engine computer fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.