Home › Code lookup › P2563
Powertrain code · Fuel and air

P2563 Turbocharger Boost Control Position Sensor "A" Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The sensor that reports the position of the turbo boost control (usually the variable vanes) is giving readings that do not match what the computer commanded.

Can I keep driving?

Usually drivable gently, but expect limited power, which can make merging or passing risky. If there's heavy smoke, a new whistle or hiss, or power drops sharply, limit driving and get it checked soon.

What to test before replacing parts

Check the boost control actuator and its position sensor signal and wiring, and inspect vacuum lines and the turbo linkage for sticking or carbon before replacing the actuator or turbo.

  1. Watch commanded versus actual vane position with a scan tool
  2. Check vacuum lines and the boost control valve if the actuator uses vacuum
  3. Check whether the actuator rod moves freely

Signs you may notice

  • Check engine light on
  • Loss of power or limp mode
  • Slow or no turbo boost
  • Sometimes black smoke

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSticking turbo vanes from carbon buildup
  • CommonFailed turbo actuator or position sensor
  • PossibleVacuum leak or bad vacuum control valve on vacuum-operated actuators
  • PossibleWiring or connector fault at the actuator
  • PossibleWorn turbo linkage

Typical repair once the cause is confirmed

Often a new turbo actuator or position sensor; sometimes the turbo vanes must be cleaned or the turbo replaced.

Repair costInsufficient verified pricing for this vehicle and repair
Replace turbo actuator or position sensor. Prepare an itemized shop request.

Where it shows up

  • Well known on Volkswagen and Audi TDI diesels with variable-vane turbos
Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2563 mean?

The sensor that reports the position of the turbo boost control (usually the variable vanes) is giving readings that do not match what the computer commanded.

Can I drive with code P2563?

Usually drivable gently, but expect limited power, which can make merging or passing risky. If there's heavy smoke, a new whistle or hiss, or power drops sharply, limit driving and get it checked soon.

What causes P2563?

Common possibilities to test include: sticking turbo vanes from carbon buildup; failed turbo actuator or position sensor; vacuum leak or bad vacuum control valve on vacuum-operated actuators; wiring or connector fault at the actuator. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.