Home › Code lookup › P2564
Powertrain code · Fuel and air

P2564 Turbocharger Boost Control Position Sensor "A" Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the turbocharger boost control position sensor and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the turbocharger boost control position sensor for rubbed-through insulation touching metal
  2. Unplug the turbocharger boost control position sensor and see if the reading changes
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Loss of power or limp mode
  • Turbo may over-boost or under-boost

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire in the turbocharger boost control position sensor shorted to ground or open
  • CommonFailed turbocharger boost control position sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the turbocharger boost control position sensor.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2564 mean?

The computer is watching the turbocharger boost control position sensor and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I drive with code P2564?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2564?

Common possibilities to test include: signal wire in the turbocharger boost control position sensor shorted to ground or open; failed turbocharger boost control position sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.