Home › Code lookup › P2566
Powertrain code · Fuel and air

P2566 Turbocharger Boost Control Position Sensor "A" Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

The computer is watching the turbocharger boost control position sensor and is seeing a signal that cuts in and out. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the wiring for the turbocharger boost control position sensor with the engine running while watching live data
  2. Check connector pins for corrosion or spread terminals
  3. Note when it happens (hot, cold, bumps) to narrow it down

Signs you may notice

  • Check engine light on
  • Loss of power or limp mode
  • Turbo may over-boost or under-boost

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose connector or chafed wire that loses contact over bumps
  • CommonTurbocharger boost control position sensor failing on and off
  • PossibleCorrosion inside the connector
  • PossiblePoor ground connection

Typical repair once the cause is confirmed

Repair the loose or corroded connection; replace the turbocharger boost control position sensor if the wiring is solid.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2566 mean?

The computer is watching the turbocharger boost control position sensor and is seeing a signal that cuts in and out. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I drive with code P2566?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2566?

Common possibilities to test include: loose connector or chafed wire that loses contact over bumps; turbocharger boost control position sensor failing on and off; corrosion inside the connector; poor ground connection. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.