P2570 Direct Ozone Reduction Catalyst Temperature Sensor Circuit High
What it means
The computer is watching the ozone-reducing radiator catalyst temperature sensor and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the ozone-reducing radiator catalyst temperature sensor
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- No change in how the car drives
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire shorted to voltage or a broken ground wire
- CommonFailed ozone-reducing radiator catalyst temperature sensor
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the ozone-reducing radiator catalyst temperature sensor.
Common questions
What does P2570 mean?
The computer is watching the ozone-reducing radiator catalyst temperature sensor and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power.
Can I drive with code P2570?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2570?
Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed ozone-reducing radiator catalyst temperature sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.