Home › Code lookup › P2586
Powertrain code · Fuel and air

P2586 Turbocharger Boost Control Position Sensor "B" Circuit

How urgent? Get it checked in the next few days

What it means

The computer is watching the turbocharger boost control position sensor and has spotted an electrical fault. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the turbocharger boost control position sensor, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Loss of power or limp mode
  • Turbo may over-boost or under-boost

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the turbocharger boost control position sensor
  • CommonBroken or chafed wire in the turbocharger boost control position sensor circuit
  • CommonFailed turbocharger boost control position sensor
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the turbocharger boost control position sensor.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2586 mean?

The computer is watching the turbocharger boost control position sensor and has spotted an electrical fault. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I drive with code P2586?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2586?

Common possibilities to test include: unplugged, loose or corroded connector at the turbocharger boost control position sensor; broken or chafed wire in the turbocharger boost control position sensor circuit; failed turbocharger boost control position sensor; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.