Home › Code lookup › P2587
Powertrain code · Fuel and air

P2587 Turbocharger Boost Control Position Sensor "B" Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The computer is watching the turbocharger boost control position sensor and is getting a signal that does not make sense for current conditions. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other codes that point to the underlying problem
  2. Compare the turbocharger boost control position sensor reading with expected values in live data
  3. Inspect the wiring and connector

Signs you may notice

  • Check engine light on
  • Loss of power or limp mode
  • Turbo may over-boost or under-boost

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing or sticking turbocharger boost control position sensor
  • CommonSticking turbo vanes or wastegate linkage
  • PossibleWiring or connector with high resistance
  • PossibleComputer software that needs an update

Typical repair once the cause is confirmed

Find out whether the turbocharger boost control position sensor itself or the system it works with is at fault, then repair or replace as needed.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2587 mean?

The computer is watching the turbocharger boost control position sensor and is getting a signal that does not make sense for current conditions. It tells the computer where the turbo boost control (vanes or wastegate) is sitting.

Can I drive with code P2587?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2587?

Common possibilities to test include: failing or sticking turbocharger boost control position sensor; sticking turbo vanes or wastegate linkage; wiring or connector with high resistance; computer software that needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.