P258A Vacuum Pump Control Circuit/Open
What it means
The computer is watching the electric vacuum pump control circuit and sees what looks like a broken or disconnected circuit. The pump supplies vacuum for the brake booster when the engine cannot make enough on its own.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the electric vacuum pump control circuit, checking for damage, corrosion or a loose fit
- Check power, ground and resistance of the part with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine or brake warning light on
- Brake pedal may feel hard
- Pump may run constantly or not at all
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the electric vacuum pump
- CommonBroken or chafed wire in the electric vacuum pump control circuit
- CommonFailed electric vacuum pump
- PossibleBlown fuse or failed relay feeding the circuit
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the electric vacuum pump.
Common questions
What does P258A mean?
The computer is watching the electric vacuum pump control circuit and sees what looks like a broken or disconnected circuit. The pump supplies vacuum for the brake booster when the engine cannot make enough on its own.
Can I drive with code P258A?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P258A?
Common possibilities to test include: unplugged, loose or corroded connector at the electric vacuum pump; broken or chafed wire in the electric vacuum pump control circuit; failed electric vacuum pump; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.