P258B Vacuum Pump Control Range/Performance
What it means
The computer is watching the electric vacuum pump control circuit and is getting a signal that does not make sense for current conditions. The pump supplies vacuum for the brake booster when the engine cannot make enough on its own.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check for other codes that point to the underlying problem
- Compare the electric vacuum pump control circuit reading with expected values in live data
- Inspect the wiring and connector
Signs you may notice
- Check engine or brake warning light on
- Brake pedal may feel hard
- Pump may run constantly or not at all
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing or sticking electric vacuum pump
- CommonA real problem in the system the part works with
- PossibleWiring or connector with high resistance
- PossibleComputer software that needs an update
Typical repair once the cause is confirmed
Find out whether the electric vacuum pump itself or the system it works with is at fault, then repair or replace as needed.
Common questions
What does P258B mean?
The computer is watching the electric vacuum pump control circuit and is getting a signal that does not make sense for current conditions. The pump supplies vacuum for the brake booster when the engine cannot make enough on its own.
Can I drive with code P258B?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P258B?
Common possibilities to test include: failing or sticking electric vacuum pump; a real problem in the system the part works with; wiring or connector with high resistance; computer software that needs an update. A shop should confirm the cause before replacing parts.