Home › Code lookup › P2600
Powertrain code · Cooling

P2600 Coolant Pump "A" Control Circuit/Open

How urgent? Get it checked in the next few days

What it means

The computer is watching the coolant pump "A" control circuit and sees what looks like a broken or disconnected circuit. Some engines use an electric pump to move coolant through the engine, turbo or heater.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Watch the temperature gauge and pull over if it climbs
  2. Look over the connector and wiring for the coolant pump "A" control circuit, checking for damage, corrosion or a loose fit
  3. Check power, ground and resistance of the part with a meter
  4. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Engine may run hot
  • Heater may blow cooler air

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the electric coolant pump
  • CommonBroken or chafed wire in the coolant pump "A" control circuit
  • CommonFailed electric coolant pump
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the electric coolant pump.

Walk through it step by step: Engine overheating →

Common questions

What does P2600 mean?

The computer is watching the coolant pump "A" control circuit and sees what looks like a broken or disconnected circuit. Some engines use an electric pump to move coolant through the engine, turbo or heater.

Can I drive with code P2600?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2600?

Common possibilities to test include: unplugged, loose or corroded connector at the electric coolant pump; broken or chafed wire in the coolant pump "a" control circuit; failed electric coolant pump; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.