Home › Code lookup › P2608
Powertrain code · Engine

P2608 Intake Air Heater "B" Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the intake air heater "B" circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Many diesels warm the incoming air with an electric grid heater for easier cold starts.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the intake air heater "B" circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Hard starting in cold weather
  • White smoke right after a cold start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the intake air heater or its relay shorted to voltage or the part open inside
  • CommonFailed intake air heater or its relay
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the intake air heater or its relay.

Walk through it step by step: Hard to start when cold →

Common questions

What does P2608 mean?

The computer is watching the intake air heater "B" circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Many diesels warm the incoming air with an electric grid heater for easier cold starts.

Can I drive with code P2608?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2608?

Common possibilities to test include: control wire to the intake air heater or its relay shorted to voltage or the part open inside; failed intake air heater or its relay; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.